Dune HD Smart H1 User Manual download pdf (Page 10)

Dune HD Smart H1 Quick Start Guide

To browse the list of network resources accessible via SMB or UPnP protocols, use "Network Browser"

item on the main screen of the player menu. NOTE: If some network resources are not shown by the

player, you may need to wait some minutes and then retry (or press the "MENU" RC button and choose

"Refresh" command).

Formatting HDD

To format a HDD attached to the player, select the drive item on the main screen of the player menu, press

the "INFO" RC button and choose "Format Disk" (to format the entire disk) or "Format Partition" (or to for-

mat an already existing disk partition only). The player will format the disk using "EXT2" ﬁ lesystem. NOTE:

To use disks formatted by the player on a Windows PC, you may need to install additional software on the

PC, such as "EXT2FSD" (http://www.ext2fsd.com/).

Switching the Player On and Off

To switch on the player, ensure the power switch on the rear panel is in «on» state, and press the «POWER»

RC button or the «on/off» button on the front panel.

To put the player into the standby mode, press the «POWER» RC button or the «on/off» button on the front

panel. To exit the standby mode, press any of these buttons again.

Depending on the player settings (see the player setup menu), the «hardware standby» or «software

standby» mode may be used. In the «hardware standby» mode, almost complete power-off takes place

and the player consumes almost no power. In the «software standby» mode, the player produces no signal

on the video output, but is still functioning. For example, if you have some storage devices connected to

the player, you may still access them from network («NAS» function of the player). Exiting the «software

standby» mode takes just a few seconds. When the player is in the «software standby» mode, it still

consumes significant power. It is not recommended to keep the player in the «software standby» mode for

a while if you do not need it.

To switch off the player completely, toggle the power switch on the rear panel. Do not do it if some drive is

connected to the player and some write operation is in progress.

NOTE: After switching off the player or putting the player into the «hardware standby» mode, it is

recommended to wait about 1 minute before switching it on again.

NAS (Network Attached Storage)

You can access storage devices connected to the player from the local network using FTP and SMB pro-

tocols. On a Windows PC, just type "ftp://ip_address" or "\\ip_address" in the Windows explorer, where

"ip_address" is the IP address of the player.

WiFi

You can use a USB WiFi adapter to connect the player to the local network via WiFi.

Please see here for the information on supported USB WiFi adapters:

http://dune-hd.com/support/hw_compat/

Limitations

Compatibility of the player with a particular hardware (A/V equipment, network equipment, disk drives, etc)

may depend on various factors (particular hardware model, speciﬁ cs of hardware installation and usage,

conﬁ guration of the player and the hardware, etc). If the player does not correctly work with a particular

hardware, try to adjust the conﬁ guration of the player or hardware, try to use the hardware in a different

way, or try to use some other hardware.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 75 76

No comments

Dune HD Smart H1 User Manual Page 10